primary winding

英 [ˈpraɪməri ˈwɪndɪŋ]

美 [ˈpraɪmeri ˈwɪndɪŋ]

一次绕组；原绕组

电力

英英释义

noun

• coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
  1. current through the primary coil induces current in the secondary coil
  Synonym:primary coilprimary

双语例句

• The using ratio of the electric energy is greatly raised by using the feedback energy from the primary winding of the high frequency transformers.
  该电源采用双管正激的主电路结构，用高频变压器的电感取代了限流电阻，利用了高频变压器初级绕组的反馈电能，极大提高了电能利用率。
• Rising Current Method at CT Primary Winding and Its Application
  电流互感器一次升流的方法与应用
• The High Tension ( HT) voltage is produced by mutual induction between the primary winding and the secondary winding, and the central soft iron core intensifies the magnetic field between them.
  通过初级绕组和次级绕组之间的互感产生出一个高电压，把两绕组联系起来的中心软体起导磁的作用，它把磁场集中起来。
• Analysis of an Oil-Immersed Current Transformer Primary Winding Failure
  油浸式电流互感器一次绕组故障实例分析
• The electronic control unit allows current to flow through the ignition coil primary winding until it senses a triggering voltage pulse from the speed sensor, or pickup coil.
  电子控制单元使电流通过初级绕组直到感知到一个从转速传感器或拾波线圈产生的触发电压脉冲。
• The strength calculation method and the structure of current transformer with U primary winding to fulfil the dynamic stability requirements are introduced, and some calculating examples are given.
  介绍了U形一次绕组电流互感器可满足动稳定要求的结构及强度计算方法，并给出了计算实例。
• If the primary current of the transformer flows into the dotted end of the primary winding, the sencondary current will flow out of the dotted end of the secondary winding.
  如果电流从变压器的原边有标记端流入，则副边的电流从有标记端流出。
• Through various short-circuit current temperature rise test results, the transformer temperature, time, and a high degree of three curves, obtained directly within the thermal region transformer primary winding height of about 83.3%.
  通过在不同短路电流条件下的温升试验，得到了变压器内部的温度与时间、纵向高度之间的关系曲线，得出变压器内部热区域主要集中在约绕组自下而上高度的83.3%区域。
• The distribution of the third harmonic magnetic field in imported large rectifier transformer is analyzed. The reason of conductor damage in winding is discussed. The overheat possibility in primary winding is expounded.
  分析了进口大型整流变压器三次谐波磁场的分布，讨论了绕组导体绝缘损坏的原因，一次绕组存在过热的可能性，提出了可采取的改进措施。
• Considering the conditions as voltage at primary winding, shortcircuit forces of windings and turns for transformer were calculated with FEM coupling circuit method under the 2D symmetrical model.
  以此起始条件设定变压器原边电压激励，利用磁路-电路耦合有限元法建立了2D轴对称模型，计算了变压器原、副边线圈及各线匝短路电磁力。